oopasob.blogg.se

Emcopy vs robocopy
Emcopy vs robocopy






emcopy vs robocopy

Moves files and directories, and deletes them from the source after they are copied.Īdds the specified attributes to copied files. Moves files, and deletes them from the source after they are copied. Using this option with the /e option and a destination directory, overwrites the destination directory security settings.

Emcopy vs robocopy plus#

Mirrors a directory tree (equivalent to /e plus /purge). Using this option with the /e option and a destination directory, allows the destination directory security settings to not be overwritten. The default value for this option is DA (data and attributes).Ĭopies files with security (equivalent to /copy:DATS).Ĭopies all file information (equivalent to /copy:DATSOU).Ĭopies no file information (useful with /purge).įixes file security on all files, even skipped ones.įixes file times on all files, even skipped ones.ĭeletes destination files and directories that no longer exist in the source. The default value for this option is DAT (data, attributes, and time stamps). If file access is denied, switches to backup mode.Ĭopies using unbuffered I/O (recommended for large files).Ĭopies all encrypted files in EFS RAW mode. This allows you to copy files you might otherwise not have access to, assuming it's being run under an account with sufficient privileges.Ĭopies files in restartable mode. Backup mode allows Robocopy to override file and folder permission settings (ACLs). In restartable mode, should a file copy be interrupted, Robocopy can pick up where it left off rather than re-copying the entire file.Ĭopies files in backup mode.

emcopy vs robocopy

This option automatically includes empty directories.Ĭopies only the top n levels of the source directory tree.Ĭopies files in restartable mode. This option automatically excludes empty directories.Ĭopies subdirectories. Specifies the options to use with the robocopy command, including copy, file, retry, logging, and job options.Ĭopies subdirectories. If you don't specify this parameter, *.* is used as the default value. Wildcard characters ( * or ?) are supported. Specifies the file or files to be copied. Specifies the path to the destination directory. Specifies the path to the source directory. Syntax robocopy ] įor example, to copy a file named yearly-report.mov from c:\reports to a file share \\marketing\videos while enabling multi-threading for higher performance (with the /mt parameter) and the ability to restart the transfer in case it's interrupted (with the /z parameter), type: robocopy c:\reports '\\marketing\videos' yearly-report.mov /mt /z Please remember to mark the replies as answers if they help.Copies file data from one location to another. So you need to allow access through your firewall from the source system to the target system with port 445 as the destination.

emcopy vs robocopy

With NetBIOS disabled, Robocopy will automatically connect to the target system using TCP port 445. You can disable NetBIOS on a network interface by accessing the interface’s TCP/IP properties, clicking the Advanced button, then clicking the WINS tab, and finally clicking the "Disable NetBIOS over TCP/IP" radio button. If you would like to force Robocopy to use the newer SMB over TCP port (445), then you can disable NetBIOS over IP on the source system. With a default installation and network parameters, Robocopy will attempt to connect to the remote host using TCP port 139. SMB-based communications use the following ports: Robocopy uses the Server Message Block (SMB) protocol to copy files between two hosts. According to my research, there is no official document list the detailed ports for robocopy.








Emcopy vs robocopy